//Connect transmitter facing inwards to pins A3, A4 and A5
//Connect microSD breakout boards as follows:
//
//  5v Pin to 5v Pin
//  GND to GND
//  CLK to Pin 13 (do not worry about LED)
//  DO to 12
//  DI to 11
//  CS to 10
//  CD to nothing.  CD is for and LED light when a microSd is connect and is not necessary for transfers

#include <VirtualWire.h>

const int transmit_pin = 9;
const int receive_pin = 2;
const int transmit_en_pin = 3;
const int chipSelect = 10;
char data;

void setup()
{
    // Initialise the IO and ISR
    vw_set_tx_pin(transmit_pin);
    vw_set_rx_pin(receive_pin);
    vw_set_ptt_pin(transmit_en_pin);
    vw_set_ptt_inverted(true); // Required for DR3100
   
    vw_setup(3000);       // Bits per sec
   
   Serial.begin(9600);
  while (!Serial) {}  // wait for Arduino
 


}

void loop()
{
    char buffMsg[] = "########This is a buffer message \n"; 
  vw_send((uint8_t *)buffMsg, 1);
  vw_wait_tx();
  delay(5000);
}